Page 1 of 1

Configuration Set

PostPosted: Wed Aug 05, 2009 12:02 pm
by jyoung
We use a commen configuration set for all of our models but it doesn't look like it is compatable with T-VEC. I'm trying to narrow down the reason why. Either the translator isn't compatiable with config sets or I need to change a setting in mine to allow it to be writable. Do you have a though in this error?


### Performing block order export for: TVEC_Example
Error using ==> performBlockExport at 20
A configuration set reference does not allow writing to parameters in the source configuration set.

Re: Configuration Set

PostPosted: Wed Aug 05, 2009 12:48 pm
by snyder
The block export temporarily turns off "ConditionallyExecuteInputs". I'll look into creating a duplicate configuration set without touching the original.

As a side note, I can't find information on how to make a configuration set read-only. Could you tell me how you are able to make the configuration set read only?

Thanks, Chris

Re: Configuration Set

PostPosted: Wed Aug 05, 2009 1:20 pm
by jyoung
You can use this command which lets you set which aspects of the config set that you can edit



setPropEnabled

setPropEnabled(CSUCfgSet,'ConditionallyExecuteInputs', 0)